②Check whether the main shaft of the crusher rotates flexibly.
③Check whether the hammer is damaged or stuck.
④ Check whether the sieve is reversed, whether the sieve is damaged, and whether the sieve hole is correct. ⑤Clean the iron on the iron separator.
⑥Check whether the suction system is normal.
(2) Startup
①Start the discharge hoist, screw auger and suction device (with suction device). ②Start the pulverizer and check the pointer of the ammeter. After the pointer of the ammeter returns from the large value to the small value, feed is started after 2 minutes of idling.
③Open the shredder air door about 5mm.
④Turn on the feeder and slowly increase the speed so that the current of the pulverizer is close to but not exceeding the rated current.
(3) Shutdown
①Close the door of the warehouse to be crushed.
② After the working current of the crusher drops, reduce the feeder speed to "0", and then close the feeder.
③Turn off the grinder after idling for 1 minute.
④Close the suction system.
⑤Close the discharge and conveying equipment.
(4) Shutdown inspection
①Check the sieve and hammer wear.
②Check whether the tax film is stuck or not transferred.
③Clean the rope and iron.
④ Check the equipment when replacing the screen and hammer, the equipment control button must be turned in the "inspection" position.